Showing posts with label Fatty 10x8. Show all posts
Showing posts with label Fatty 10x8. Show all posts
Saturday, 2 July 2016

back on track building the CH250 Spacy/Elite

›
You could pretty say this is a sad excuse for a blog. The latest entry was about six months ago! I've been busy moving from the old work...
3 comments:
Saturday, 10 October 2015

new front fork setup for the CH250 Spacy/Elite

›
I found the perfect front fork for the CH250 Spacy/Elite; a 2001 Aprilia RS125 upside down. It has the proper length and make the whole sco...
3 comments:
Saturday, 29 August 2015

DIY tyre blaster for the Spacy/Elite fatty

›
Built myself a tyre blaster from a compressor tank, 11/2 inch water valve and pipe. Works nicely!

Spacy/Elite swing arm so far

›
Been a while since my last post. The swing arm and shock mount is almost finished. Only some small reinforcements. But it is working; I...
Thursday, 7 May 2015

Elite/Spacy at the Rusty Gold Swap+Meet Amsterdam

›
Last Sunday I attended the Rusty Gold Swap+Meet in Amsterdam to show my freshly built motorcycle work bench. I needed a bike to show how th...
Saturday, 7 February 2015

quick tyre flip for the Helix and some work on the lathe for the Elite fatty

›
 Used the drill press to release the old tyre from the rim. Quick and easy without tyre spoons flying around...   And some good leg wor...
Wednesday, 26 February 2014

the subframe part1 is on the frame

›
Today Jeroen welded the subframe. It fits nicely between the frame and side panels. The right engine cover sits right be...
Wednesday, 5 February 2014

drawings for the subframe and swing arm CH250 Spacy/Elite

›
I'm making drawings for the subframe and swing arm by making templates on paper from gaskets and pin gauges. After scanning t...

working on the stretch subframe CH250 Spacy Elite

›
I'm working on the subframe to determine how long it needs to be. The clearance between the wheel and the spring was pr...
Wednesday, 25 December 2013

the CH250 engine is back on the frame

›
I put the engine back on the frame to start working on the subframe. It needs an offset of 41mm. With the use of templates ...
Wednesday, 11 December 2013

getting somewhere with the CH250 Spacy Elite hub

›
Today, I did some work on the hub. I made a removable center piece, so you can fit different rims.This one's inside diameter is 62mm.If...